Baldwin Sliding
Door Locks
Please
scroll down to purchase online.
 
1.5
(38MM) BACKSET - SPECIFICATIONS
-
Heavy gauge steel case for maximum
strength.
-
Component parts are made primarily of solid forged
brass
-
Flush edge pull provides convenient
door mobility in pocket application.
-
Fully reversible for right and left hand
doors.
-
STEEL
CASE: .75" x 2.5" x 5.5"
-
*FRONT:
1' x 8" . Available in widths of 1.375" or 1.75"
-
BACKSET:
1.5"
-
STRIKE:
.5"x 1.25" x .937" projection
-
CYLINDER:
Standard mortise type with 03 keyway and two nickel silver keys. Locks are
furnished with a 1" length cylinder unless specified otherwise.
Optional keyways available.
-
PREPARATION:
2.562" deep x 5.75" high cut-out is required.
IMPORTANT:
FOR DOOR THICKNESS 1.375" AND
1.75". OTHER DOOR THICKNESS ARE NOT AVAILABLE.
A keyed function must be
used on pairs of
sliding
doors where
security is a concern.
8570.ADAP
Baldwin Trim adapter for installing levers
-
Designed to adapt a lever or a knob to a sliding door lock.
-
Set contains parts to modify one side of a sliding door lock: one spindle,
one rose, and installation instructions.
-
Lever or Knob must be purchased separately. Use a solid spindle if knob or
lever is installed on both sides.
PASSAGE
Latch bolt by lever either side.
One
in a box with necessary fasteners.
PRIVACY
Latch bolt by lever either side, except when locked
by turn piece inside. Furnished with Emergency Key No. 0417 for unlocking
outside. One in a box with necessary fasteners.
PATIO
Latch bolt by lever either side, except when locked by turn piece inside. One in a box with necessary fasteners.
ENTRANCE
Latch bolt by lever either side, except when locked by cylinder outside or turn
piece inside. Turn piece must be used for locking to prevent accidental
lockouts. One in a box with necessary fasteners.
DOUBLE
CYLINDER
Latch bolt by lever either side, except when locked by cylinder outside or
cylinder inside. Blocking rings required for proper cylinder operation on
1.375'" and 1.750" thick doors. One in a box with necessary fasteners.
IMPORTANT: For cylinder clearance, a minimum pocket width of 2.50"
(54mm) is required.
SIZE:
.75" x 1.625" x 3.875" (19x41x98mm)
Specially designed spring loaded Edge Pull returns lever flush
with face plate. Narrow design eliminates installation problems on thin door
conditions. Intended for use on pocket door applications.
0458
SOLID
FORGED BRASS FLUSH PULL
SIZE:
1.5" x 3.5" (38x89mm)
THICKNESS OF FLANGE: .187" (5mm)
Decorative flush pull designed to be used as a sash lift or
sliding door pull if pocket allows clearance. Extra heavy solid forged brass construction.
|
Visit Our sister Site BaldwinBrass Hardware.com for even
more products!